
PIC18F2455/2550/4455/4550

28/40/44-Pin High-Performance, Enhanced Flash USB
Microcontrollers with nanoWatt Technology

Universal Serial Bus Features:

 USB V2.0 Compliant
 Low Speed (1.5 Mb/s) and Full Speed (12 Mb/
 Supports Control, Interrupt, Isochronous and
  Transfers
 Supports up to 32 endpoints (16 bidirectional)
 1-Kbyte dual access RAM for USB
 On-chip USB transceiver with on-chip voltage
  regulator
 Interface for off-chip USB transceiver
 Streaming Parallel Port (SPP) for USB streaming
  transfers (40/44-pin devices only)

Power-Managed Modes:

 Run: CPU on, peripherals on
 Idle: CPU off, peripherals on
 Sleep: CPU off, peripherals off
 Idle mode currents down to 5.8 A typical
 Sleep mode currents down to 0.1 A typical
 Timer1 oscillator: 1.1 A typical, 32 kHz, 2V
 Watchdog Timer: 2.1 A typical
 Two-Speed Oscillator Start-up

Flexible Oscillator Structure:

 Four Crystal modes including High Precision PLL
  for USB
 Two External Clock modes, up to 48 MHz
 Internal oscillator block:
  - 8 user-selectable frequencies, from
    31 kHz to 8 MHz
  - User-tunable to compensate for frequency drift
 Secondary oscillator using Timer1 @ 32 kHz
 Dual oscillator options allow microcontroller and
  USB module to run at different clock speeds
 Fail-Safe Clock Monitor
  - Allows for safe shutdown if any clock stops

Peripheral Highlights:

 High-current sink/source 25 mA/25 mA
 Three external interrupts
 Four Timer modules (Timer0 to Timer3)
 Up to 2 Capture/Compare/PWM (CCP) modules:
  - Capture is 16-bit, max. resolution 6.25 ns (TCY/16)
  - Compare is 16-bit, max. resolution 100 ns (TCY)
  - PWM output: PWM resolution is 1 to 10-bit
 Enhanced Capture/Compare/PWM (ECCP) module:
  - Multiple output modes
  - Selectable polarity
  - Programmable dead time
  - Auto-Shutdown and Auto-Restart
 Enhanced USART module:
  - LIN bus support
 Master Synchronous Serial Port (MSSP) module
  supporting 3-wire SPI (all 4 modes) and I2C
   Master and Slave modes
 10-bit, up to 13-channels Analog-to-Digital Converter
  module (A/D) with programmable acquisition time
 Dual analog comparators with input multiplexing

Special Microcontroller Features:

 C compiler optimized architecture with optional
  extended instruction set
 100,000 erase/write cycle Enhanced Flash
  program memory typical
 1,000,000 erase/write cycle Data EEPROM
  memory typical
 Flash/Data EEPROM Retention: > 40 years
 Self-programmable under software control
 Priority levels for interrupts
 8 x 8 Single-Cycle Hardware Multiplier
 Extended Watchdog Timer (WDT):
  - Programmable period from 41 ms to 131s
 Programmable Code Protection
 Single-Supply 5V In-Circuit Serial
  Programming (ICSP) via two pins
 In-Circuit Debug (ICD) via two pins
 Optional dedicated ICD/ICSP port (44-pin devices only)
 Wide operating voltage range (2.0V to 5.5V)